Plxsys Wiki

Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.

The edit can be undone. Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.

Latest revision Your text
Line 38: Line 38:
 
==== The Extrusion Control Panel ====
 
==== The Extrusion Control Panel ====
 
Stub. Information coming.
 
Stub. Information coming.
 
=== Block Set ===
 
The "Block Set" mode allows you to place a block with any position, rotation and size (within size limits). Once the block has been placed, if it doesn't fit in the grid layout or any nearby existing blocks, then it will form its own Block Set. Once the new Block Set has been established, it can be contributed to via the Single or Extrude modes.
 
   
 
==Tips and tricks==
 
==Tips and tricks==

Please note that all contributions to the Plxsys Wiki are considered to be released under the CC BY-NC-SA 3.0

Cancel Editing help (opens in new window)

This page is a member of 1 hidden category: